HP Hitachi Dynamic Link Manager Software User Manual
Page 200

Use this parameter to place online, at one time, all the paths that pass
through a specific channel adapter port. The command will place online all
the paths that pass through the channel adapter port to which the path
with the specified AutoPATH_ID is connected. You can specify this
parameter only when the HDLM management-target device is the
Thunder 9500V series, Lightning 9900 series, Lightning 9900V series,
Hitachi USP, Hitachi AMS2000/AMS/WMS/SMS series, Universal Storage
Platform V/VM, and Virtual Storage Platform.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page 6-29
. Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the channel adapter port 0A. In this example, a path whose
AutoPATH_ID is 000002 is connected to the target channel adapter
port:
>dlnkmgr online -cha -pathid 000002
KAPL01057-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
-pathid AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page 6-29
Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-hbaportwwn HBA-port-WWN [-tid target-ID -hlun host-LU-number]
Specify this parameter to place online all paths connected to the HBA port
indicated by the specified HBA port WWN. If the -tid and -hlun
parameters are not specified, all paths on the specified HBA port WWN
are placed online. Only one set of values can be specified for the -
hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
6-12
Command Reference
Hitachi Dynamic Link Manager User Guide (for Windows(R))