beautypg.com

When mscs is used -55 – HP Hitachi Dynamic Link Manager Software User Manual

Page 121

background image

24

.

Connect cables to all the HBAs to change the configuration to a multi-path

configuration.

Figure 3-4 Single Path Configuration and Multi-path Configuration on page

3-55

shows a single path configuration and a multi-path configuration.

Figure 3-4 Single Path Configuration and Multi-path Configuration

25

.

Check the path information as described in

Checking the Path

Configuration on page 3-68

to make sure that you have successfully

assembled a multi-path configuration.

When MSCS Is Used

The following provides explanations of how to install MSCS before and after

an HDLM installation.

Installing MSCS after an HDLM installation

To install HDLM and then MSCS:

1

.

Shut down all the hosts.

2

.

Make sure that all the hosts that make up the cluster system have been

fully shut down.

3

.

Restart each host.
Restart them all in the single path configuration.

4

.

Log on to Windows as a member of the Administrators group.

5

.

Save the license key file directly under the Windows installation-

destination drive. Also, instead of using the license key file, you can

directly specify a license key during the installation of HDLM.

installation-drive:\hdlm_license

The license key file will be deleted after the installation finishes.

6

.

Perform the installation.

Creating an HDLM Environment

3-55

Hitachi Dynamic Link Manager User Guide (for Windows(R))

This manual is related to the following products: