HP Hitachi Dynamic Link Manager Software - Manual (Page 196)

when all the paths which pass the specified CHA port are
placed in the Offline(C) status, enter y. Otherwise, enter
n. [y/n]: y
KAPL01061-I 2 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
>
-pathid AutoPATH_ID
Use this parameter to place a single path offline.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see view
(Displays Information) on page 6-29 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the offline operation.
-hbaportwwn HBA-port-WWN [-tid target-ID -hlun host-LU-number]
Use this parameter to place offline all paths connected to the HBA port
indicated by the specified HBA port WWN. If niether the -tid parameter
nor the -hlun parameter are specified, all paths that pass through the
specified HBA port WWN will be placed offline. Only one set of values can
be specified for the -hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
For target-ID, specify the target ID portion of PathName. Leading zeroes
can be omitted from the target ID (0000000000000001 and 1 are the
same value). The parameter is not case sensitive.
For host-LU-number, specify the host LU number portion of PathName.
Leading zeroes can be omitted from the host LU number (0001 and 1 are
the same value).
To display HBAPortWWN and PathName, execute the view operation as
follows:
>dlnkmgr view -path -hbaportwwn
For details on how to execute the view operation and display the HBA
port WWN and path name, see Parameters Used When Displaying Path
Information on page 6-38 in Parameters on page 6-31 .
Example
The following shows an example of placing offline the paths for which
the HBA port WWN is 10000000C93213BA, target ID is
0000000000000001, and host LU number is 0000 while confirming
command operation.
>dlnkmgr offline -path –hbaportwwn 10000000C93213BA –tid 1 –
hlun 0
KAPL01052-I The currently selected paths will be changed to
the Offline(C) status. Is this OK? [y/n]: y
KAPL01053-I If you are sure that there would be no problem
6-8
Command Reference
Hitachi Dynamic Link Manager User Guide (for Windows(R))