HP Hitachi Dynamic Link Manager Software User Manual
Page 107
13
.
Check the results of the installation.
If you have performed an unattended installation, check the installation
results from the command prompt.
14
.
After the installation finishes, execute the dlmprsvkey utility with the -v
parameter specified.
Execute the following command:
HDLM-installation-folder\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the dlmprsvkey utility is
unique among all the other hosts in the SAN. If the PRSV key is not
unique or is not registered, or if the KAPL09131-W message appears,
execute the dlmprsvkey utility with the -r parameter specified to re-
register the PRSV key. If the PRSV key is not registered, the HDLM
functions might not properly operate. For details about the dlmprsvkey
The dlmprsvkey Utility for Registering an HDLM Persistent
.
If you used a license key file, it will be deleted after the installation
finishes. The KAPL09115-W message will appear if deletion of this file
fails. If this happens, delete the file manually.
15
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 24)
whether HDLM has been successfully installed.
16
.
For all the hosts that make up the cluster system, perform steps 1 to 15.
17
.
Confirm that all the hosts that make up the cluster system have been
fully shut down.
18
.
Modify the storage system settings.
Modify the storage system settings by following the procedure described
in the maintenance documentation for that particular storage system.
19
.
Restart each host.
20
.
Log on to Windows again as a member of the Administrators group.
21
.
Make sure that the program is running properly, by examining the results
of the dlnkmgr command's view operation.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Creating an HDLM Environment
3-41
Hitachi Dynamic Link Manager User Guide (for Windows(R))