HP Hitachi Dynamic Link Manager Software - Manual (Page 145)

KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
>
After you have set up the collection of audit log data, use the following
command to make sure that the setting has been specified correctly:
>dlnkmgr view -sys -audlog
Audit Log : on(6)
Audit Log Category : a11
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
>
Setting Up Integrated Traces
When HDLM is used, the dlnkmgr command and GUI operation logs are
output to the integrated trace information files of Hitachi Network Objectplaza
Trace Library (HNTRLib2) (installation-destination-drive:\Program
Files
#
\HITACHI\HNTRLib2\spool\Hntr2n.log files (n indicates a file
number)).
#
For Windows Server 2003 (excluding the x86 edition) or Windows Server
2008 (excluding the x86 edition), Program Files is Program Files
(x86).
If a lot of integrated trace information is output, the older information might
end up getting deleted in a very short amount of time. Also, if a large amount
of integrated trace information is suddenly all output at the same time, any
integrated trace information that is overflowing the buffer might not be saved
into the integrated trace files. To save as much information as possible,
change the settings for Hitachi Network Objectplaza Trace Library, increasing
the integrated trace file size and buffer size. Note that if the values are too
large, it will place a heavy load on the system. When determining these
values, be sure to consider these operational tradeoffs.
Table 3-20 Default and Recommended Values for the Integrated Trace File
Settings on page 3-79 shows the default and recommended values for the
integrated trace file settings.
Table 3-20 Default and Recommended Values for the Integrated Trace File
Settings
Setting Default value
Recommended
value
Integrated trace file size 256 (KB) 4096 (KB)
Number of integrated trace files 4 8
Buffer size per
monitoring
interval
Monitoring cycle 10 (seconds) 5 (seconds)
Creating an HDLM Environment
3-79
Hitachi Dynamic Link Manager User Guide (for Windows(R))