Parameters, To display the format of the online operation -11, Parameters -11 – HP Hitachi Dynamic Link Manager Software User Manual
Page 199: To place paths online -11

|-hbaportwwn HBA-port-WWN [-tid target-ID -hlun host-LU-
number]]
[-s]
To Display the Format of the Online Operation
dlnkmgr online -help
Parameters
To Place Paths Online
-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because the online is always used for paths,
so it is assumed.
Specify the paths to be taken online by using the -hba, -cha, -pathid, or
-hbaportwwn parameter. If you do not specify any of these parameters,
the command will place all the offline paths online. If there is a path that
cannot be placed online, a message asks whether you would like to
continue processing. To ignore the offline path that cannot be placed
online and to continue processing, enter y. To stop the processing, enter
n.
-hba host-port-number.bus-number
Use this parameter to place online, at one time, all the paths that pass
through a specific HBA port. The command will place online all the paths
connected to the HBA port that has the specified host port number and
bus number.
Specify the host port number and bus number of the target HBA port: the
numbers are found in the PathName field displayed using the view
operation. Enter a period between these two parameter values. For
details about the view operation, see
view (Displays Information) on page
. Leading zeros of each parameter value can be omitted; however,
when the host port number or bus number of the target HBA port is 0000,
enter 0000 or 0 for the corresponding parameter value.
Example
The following example shows how to place online all paths connected
to an HBA port whose host port number is 0001 and bus number is
0001:
>dlnkmgr online -hba 1.1
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
-cha -pathid AutoPATH_ID
Command Reference
6-11
Hitachi Dynamic Link Manager User Guide (for Windows(R))