HP Hitachi Dynamic Link Manager Software - Manual (Page 130)

Note:
If you want to install all HDLM components on a host on which the HDLM
Core components have been installed, use an unattended installation.
When you install HDLM without using the unattended installation option,
only the HDLM Core components, which were already installed in the
previous environment, will be installed. For details about unattended
installations, see The installhdlm Utility for Installing HDLM on page
7-16 .
Migrating from HDLM 5.4 or Earlier to HDLM 5.5 or Later
To upgrade from HDLM 5.4 or earlier:
1
.
Copy the following files to any location other than the HDLM installation
folder.
dlmmgr.xml is a file that specifies information needed to run HDLM
managers. dlmwebagent.properties is a file that specifies information
needed for linkage with Global Link Manager. dlmwebagent.properties
only exists in HDLM 05-02 or later. If you migrate to HDLM 5.9.1 or later,
you do not need to copy the dlmwebagent.properties file.
\HDLM-installation-folder\config\dlmmgr.xml
\HDLM-installation-folder\config\dlmwebagent.properties
2
.
Uninstall HDLM by referring to the HDLM manual for the corresponding
version.
If you uninstalled HDLM 5.4, go to step 3 because you need to delete the
HDLM driver setup information files from the system before restarting the
host.
In other cases, go to step 4.
3
.
Do a search for any setup information files (files with the inf file
extension) that satisfy all of the following conditions:
¢
The file is stored in the following folder:
Windows-installation-folder\inf
¢
The file contains the text dlmfdrv.sys (a driver file).
¢
The file has the name oemn.inf(where n is a number).
Delete any setup information files that satisfy all of the above conditions.
In addition, delete the files that have the same names as the above files,
but with the extension pnf (oemn.pnf).
If you do not delete the correct files, the host might not run properly.
Before deleting a file, make sure that it satisfies all of the above
conditions.
4
.
Perform a new HDLM installation by following the procedure in Installing
HDLM on page 3-24 .
5
.
Copy the files copied in step 1 to the following location, and then
overwrite the existing files:
3-64
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))