HP Hitachi Dynamic Link Manager Software - Manual (Page 175)

Figure 4-1 Using the command to confirm that an LU has been added on
page 4-17 shows an example of using the command to confirm that an
LU has been added. For details about the HDLM GUI, see the HDLM GUI
Help.
Figure 4-1 Using the command to confirm that an LU has been
added
5
.
For the new LU, write a signature, create partitions, and then format it.
Note:
The PathID is determined by the system choosing the smallest,
available number that is not already in use for another path. For
example, when a path is deleted and then a new path is added, the
PathID for the added path might not be the same number as the
deleted PathID.
When MSCS is used
1
.
Add an LU.
2
.
Stop node B.
3
.
On node A, perform the steps shown in When MSCS is not used.
4
.
Stop node A, and then start node B.
5
.
On node B, perform the steps shown in When MSCS is not used.
When you create a partition, assign the same drive letter as the one
assigned for node A in step 3.
6
.
Stop node B, and then restart node A.
7
.
On node A, register the new LU in MSCS, and set it up.
8
.
Restart node B.
HDLM Operation
4-17
Hitachi Dynamic Link Manager User Guide (for Windows(R))