Viewing lu information, Viewing lu information -7 – HP Hitachi Dynamic Link Manager Software User Manual
Page 165

operation with the -hba parameter specified. The following shows an
example of executing this command:
>dlnkmgr offline -hba 1.1
KAPL01055-I All the paths which pass the specified HBA port will
be changed to the Offline(C) status. Is this OK? [y/n]:y
KAPL01056-I If you are sure that there would be no problem when
all the paths which pass the specified HBA are placed in the
Offline(C) status, enter y. Otherwise, enter n. [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
>
3
.
Check to see if the statuses of all the applicable paths have changed.
The following example shows how to execute the command:
>dlnkmgr view -path
Viewing LU Information
This section explains how to display LU information by using an HDLM
command.
To display LU information, execute the dlnkmgr command's view operation
with the -lu parameter specified. The following shows an example in which
the command is executed:
>dlnkmgr view -lu
Product : 9500V
SerialNumber : 3679
LUs : 3
iLU HDevName PathID Status
0110 G 000002 Online
000008 Online
0111 F 000001 Online
000007 Online
0112 E 000000 Online
000006 Online
Product : 9970/9980
SerialNumber : 15001
LUs : 3
iLU HDevName PathID Status
0580 J 000005 Online
000011 Online
0585 I 000004 Online
000010 Online
058A H 000003 Online
000009 Online
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
>
HDLM Operation
4-7
Hitachi Dynamic Link Manager User Guide (for Windows(R))