KROHNE OPTIFLEX 2200 C_F EN - Manual (Page 97)

SERVICE
7
97
OPTIFLEX 2200 C/F
www.krohne.com 07/2013 - 4000668002 - HB OPTIFLEX 2200 R02 en
7.1 Periodic maintenance
No maintenance is necessary.
7.2 Keep the device clean
Obey these instructions:
• Keep the thread of the terminal compartment cover clean.
• If dirt collects on the device, clean it.
7.3 How to replace device components
7.3.1 Service warranty
Servicing by the customer is limited by warranty to:
• The removal and installation of the device.
• Compact version:
Compact version: Compact version: Compact version: The removal and installation of the signal converter (with the weather
protection, if this option is attached). For more data, refer to
How to turn or remove the signal
converter on page 43.
• Remote (field) version: Remote (field) version: Remote (field) version: Remote (field) version: The removal and installation of the remote converter and/or the probe
housing. For more data, refer to
How to turn or remove the signal converter on page 43.
• Replacement of signal converters of other TDR devices: Replacement of signal converters of other TDR devices: Replacement of signal converters of other TDR devices: Replacement of signal converters of other TDR devices: The removal of a BM 100 A, BM 102
or OPTIFLEX 1300 signal converter and installation of the OPTIFLEX 2200 signal converter.
For the procedure, refer to
Replacement of the BM 100 signal converter on page 98.
For more data on how to prepare the device before you send it back, refer to Returning the
device to the manufacturer on page 112.
WARNING!
Do not use bleach to clean the signal converter.
WARNING!
Only approved personnel can do an inspection of the device and repairs. If you find a problem,
send the device back to the supplier for inspection and/or repairs.
INFORMATION!
The converter housing (compact or remote version) can be detached from the process
connection assembly under process conditions. For more data, refer to How to turn or remove
the signal converter on page 43
.