KROHNE OPTIFLEX 2200 C_F EN - Manual (Page 75)

OPERATION
6
75
OPTIFLEX 2200 C/F
www.krohne.com 07/2013 - 4000668002 - HB OPTIFLEX 2200 R02 en
2.0.0 Supervisor menu
Menu
No. Function Function description Selection list Default
2.1.0 COMMISSION.
2.1.0 COMMISSION. This starts a quick set-up procedure
applicable to most applications. The
supervisor can give the tank height (TANK
HEIGHT), output function (OUTPUT
FUNC.), current output range (RANGE I),
4 mA setting (SCALE 4mA), 20 mA setting
(SCALE 20mA), error delay (ERROR
DELAY) and tag name (TAG NAME).
2.2.0 TESTS
2.2.1 SET OUTPUT This sets the analog output to a test value
[mA] selected from a list. The output will
change to the selected value after 5
seconds, independent of the measured
value.
3.5, 4, 6, 8, 10, 12, 14, 16,
18, 20 or 22 mA
3.5 mA
2.2.2 DIAGNOSTIC This starts the hardware test. Push [>>>>]
many times to show: the time of operation
(D1), temperature of the electronic
converter board (T1), loop current (I1),
load current (I2), voltage 5.6 V (V1), voltage
on capacitors (V2), voltage 3.3 V (V3),
amplitude reference pulse (P1), amplitude
level pulse (P2), amplitude probe end
pulse (P3), reset counter (C1). If you push
[>>>>] again, the display goes back to the
menu level.
2.3.0 BASIC PARAM.
2.3.1 TANK HEIGHT The distance from the tank connecting
flange face / thread stop down to the tank
bottom.
min-max:
0…80 m / 0…262.48 ft
If tank height is
not specified in
customer order,
the probe length
value is used as
an alternative
2.3.2 TIME CONST. Increasing the time constant will
smoothen the integrated readings,
decreasing will roughen the readings.
min-max:
0 to 100 seconds
5 seconds
2.3.3 PROBE LENGTH Probe length is the distance from the
flange face / thread stop of the device
down to the bottom end of the probe
(including counterweight for cable
versions). If probe length has been
modified, enter the new value here. For
more data, refer to How to decrease the
length of probes on page 89.
min:
2.3.4 BLOC. DIST. +
3.1.1 COUNTERWEIGHT
max.:
40 m / 131.23 ft
This value is
given in
customer order
2.3.4 BLOC. DIST. Blocking distance. The non-measuring
range at the top of the probe. It depends
on the probe type and the installation.
min:
0 m / 0 ft
max:
2.3.3 PROBE LENGTH
50 mm / 1.97¨
2.3.5 TAG NAME The device has a code (tag name) to
identify it. If the tag name is given in the
customer order data, it will be set at the
factory. A maximum of 8 characters can
be used.
? TANK 01