KROHNE OPTIFLEX 2200 C_F EN - Manual (Page 69)

OPERATION
6
69
OPTIFLEX 2200 C/F
www.krohne.com 07/2013 - 4000668002 - HB OPTIFLEX 2200 R02 en
6.3 Configuration mode
6.3.1 General notes
Change the settings of your device in Configuration Configuration Configuration Configuration mode. Data about the menus is given on page
74. You can:
• Use the 1.0.0 INFORMATION 1.0.0 INFORMATION 1.0.0 INFORMATION 1.0.0 INFORMATION menu to read settings, device software versions and error
records. For more data about the Information menu, refer to Table 1: Info.
• Use the 2.0.0 SUPERVISOR 2.0.0 SUPERVISOR 2.0.0 SUPERVISOR 2.0.0 SUPERVISOR menu to commission the device, to run diagnostic tests, set up a
conversion table for volume or mass measurement, change critical parameters for difficult
process conditions, reset the device and change basic parameters (tank height etc.), output
settings, HART Address etc. For more data about the Supervisor menu, refer to Table 2:
Supervisor.
6.3.2 How to get access to the commissioning menu
Do the steps that follow:
• Push the [>>>>] button.
i This shows the Information Information Information Information menu. The Information Information Information Information menu is read only and does not have
password security.
• Push the [ ] button one time to scroll up to the Supervisor Supervisor Supervisor Supervisor menu.
i The screen shows the text "2.0.0 SUPERVISOR".
• Push the [>>>>] button one time.
i The screen shows a line. You must enter the password. Push the buttons under the display
screen 6 times (in total and in a given order) to to get access to Configuration mode.
• Type in the password. The factory-set password is [> >>>], [^ ^ ^ ^], [ ], [ ], [>>>>] and [^ ^ ^ ^].
i The device shows the text "2.1.0 COMMISSION.". Make a selection from the items in the
supervisor menu.
INFORMATION!
It is not possible to enter the 3.0.0 SERVICE and 4.0.0 MASTER menus. These menus are for
factory calibration and approved personnel only.
CAUTION!
SIL-approved devices: For data about critical device parameters for SIL approval, refer to the
Safety Manual (SIL approval).
INFORMATION!
HOW TO SET THE SUPERVISOR PASSWORD TO "ON" OR "OFF"
The supervisor password is set to "on" by default. If it is necessary to set this function to "off",
refer to Function description on page 74
, Table 2: Supervisor menu, menu item PSWD YES/NO
(2.7.4).
INFORMATION!
HOW TO CHANGE THE SUPERVISOR PASSWORD
You can change the password for the supervisor menu. For more data, refer to Function
description on page 74
, Table 2: Supervisor menu, menu item PASSWORD (2.7.5).