KROHNE OPTIFLEX 1300C EN - Manual (Page 75)

OPERATION
6
75
OPTIFLEX 1300 C
www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en
7 Tank Shapes The Wizard adds this step if you
select "Yes" in step 4. This sub-
procedure uses the
information given here to find
the volume. You have to type in
the tank shape, height, width
and length.
... ...
8 Conversion Unit The conversion unit is given as
a volume if the product density
is given. If not, choose a mass
unit.
m3, L, US gal, GB gal, ft3,
bbl or Tons, kg, US Tons, GB
Tons
m3 or Tons
9 Mass Table A table that converts product
level to product mass. If you
selected "Yes" in step 4, make
entries in the table in volume
units. Push[ ] or [ ] to
select a line and push [>>>>] to
change values automatically
supplied by the device.
Sub-
menu
Conversion
submenu
[Free Unit] [Free Unit] [Free Unit] [Free Unit]
If you cannot find the units or
tank shape in the menu, you
can customize the conversion
table.
-
1 Do you want to use
a free unit?
Select "Yes". Yes, No
2 Custom. Length
Unit
A non-standard length unit for
the conversion table. This is
defined by the supervisor.
FREE_UNIT
3 Custom. Length
Ratio
The conversion factor between
the length unit selected in
C.5.1.4 (length unit) and C.5.1.7
(customer length unit). This
ratio is a multiple of 1 mm.
min-max: 1…99999 1
4 Custom. Conv. Unit A non-standard conversion unit
for the conversion table. This is
defined by the supervisor.
FREE_UNIT
5 No. of Entries The number of lines in the
conversion table.
min-max: 0…50 2
6 Volume/Mass
Table
A table that converts product
level to another physical
parameter. Push[ ] or [ ] to
select a line and push [>>>>] to
change values.
... Current changes
must be saved or
cancelled before
proceeding
Save, Cancel 4 Save
A.1.5 A.1.5 A.1.5 A.1.5 Outputs Outputs Outputs Outputs Follow this procedure to Follow this procedure to Follow this procedure to Follow this procedure to
describe the output describe the output describe the output describe the output
characteristics. characteristics. characteristics. characteristics.
–
1 Output 1: Output
Function
Select an output function to
scale the current values
(output 1). This is not displayed
in the operator mode.
1 solid/liquid: 1 solid/liquid: 1 solid/liquid: 1 solid/liquid: Level,
Distance, Volume (Mass),
Ullage Volume; 2+ liquids: 2+ liquids: 2+ liquids: 2+ liquids:
Interface Level, Interface
Distance, Interface Volume,
Layer, Layer Volume
Level
2 Output 1 (HART):
4 mA
This assigns a measurement
value to 4 mA (output 1).
min-max:
0…20 m / 0…65.62 ft
0 m / 0 ft
Menu
No. Step Function Function description Selection list Default