KROHNE OPTIFLEX 1300C EN - Manual (Page 136)

8
TECHNICAL DATA
136
OPTIFLEX 1300 C
www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en
8.3 Pressure/temperature table for probe selection
Make sure that the transmitters are used within their operating limits.
Figure 8-3: Pressure/temperature table for probe selection in °C and barg
Figure 8-4: Pressure/temperature table for probe selection in °F and psig
1 Process pressure, P
s
[barg]
2 Process connection temperature, T [°C]
3 Process pressure, P
s
[psig]
4 Process connection temperature, T [°F]
5 All probes
6 All probes. This does not include the Ø8 mm / 0.32¨ single cable probe.
7 High-Pressure (HP) version of the Ø2 mm / 0.08¨ single cable probe
8 High-Temperature/High-Pressure (HT/HP) version of the Ø2 mm / 0.08¨ single cable probe
9 High-Temperature (HT) version of the Ø2 mm / 0.08¨ single cable probe
-50 0 50 100 150 200 250 300
0
40
60
100
280
300
-58 0 120 210 300 390 480 570
0
580
870
1450
4060
4350
WARNING!
The minimum and maximum process connection temperature and the minimum and maximum
process pressure also depends on the gasket material selected. Refer to "Pressure and
temperature ranges" on page 19
.