KROHNE OPTIFLEX 1300C EN - Manual (Page 117)

SERVICE
7
117
OPTIFLEX 1300 C
www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en
1 Connect the 50 ohm wire connector to the process conection with an 8 mm open-end wrench.
2 Before you attach the adaptor, turn the adaptor 360° to prevent damage to the 50 ohm wire.
3 Attach the adaptor to the process connection. Tighten the 4 socket head screws with a 5 mm
Allen wrench.
4 Put the OPTIFLEX 1300 signal converter on the adaptor. Make sure that the adaptor fully en-
gages in the mating part (signal converter).
5 Tighten the socket set screw at the bottom of the signal converter with a 5 mm Allen wrench.
Procedure 3A: How to attach the OPTIFLEX 1300 signal converter (non-Ex devices)
Figure 7-6: Procedure 3A: How to attach the OPTIFLEX 1300 signal converter (non-Ex devices)