KROHNE OPTIFLEX 1300C EN - Manual (Page 41)

INSTALLATION
3
41
OPTIFLEX 1300 C
www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en
• Attach a lock nut to the threaded rod below the process connection. Turn the nut until it is ¾
along the length of the rod.
• Attach a union nut to the threaded rod below the process connection.
• Use two 8 mm open-end wrenches to tighten the union nut against the lock nut.
Figure 3-31: How to assemble the segmented single rod probe: part 1
CAUTION!
Make sure that the nuts are tight and the rod probe cannot loosen.