Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 98)

Training Manual
Micro-Tools Lab
8 - 10
• A confirmation dialog box will appear next as shown below:
Figure 8.12.
Micro-Tools New
Controller
• Click on the Yes button on this dialog. Micro-Tools will create the controller
folder and an offline default database for the controller within the folder. A status
indictor showing the percentage of the database loaded will be displayed as shown
in the next figure:
Figure 8.13.
Micro-Tools New
Controller
6. Upload database from the controller: As soon as the offline database is loaded, Micro-
Tools will look for a controller with the same name on the network. If this controller is
found, you can upload this controller’s database to the new folder. Refer to the following
dialog box.
Figure 8.14.
Micro-Tools New
Controller
• Click on Yes on this dialog box to upload the database from the controller. A
status indicator showing the progress will be displayed next as shown in the next
figure.
Figure 8.15.
Micro-Tools New
Controller
• If the controller is not connected to the network at the time the controller folder is
created, the standard default database will be used. Micro-Tools will open another
dialogue box to allow you to specify the desired controller model number. If you
know the desired features of the controller, you can enter them at this point. If you
do not know the features of the controller the default can be used and the model
number can be adjusted at a later time.