Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 119)

Training Manual
F-CIM Lab
9 - 5
Figure 9 .1.
F-CIM Program
Block Diagram
SP 0
F-CIM 044
RSP RE STV SWSPT
SP
SP PV
DV
DEV 0
F-CIM 047
DV
CO
PID 0
F-CIM 041
RF CTC
CO
OUT
A/M 0
F-CIM 043
OTV SWOTV AE
READ
F-CIM 086
WRITE
F-CIM 087
AUT
B
ANO 0
ANI 2
CCI 1
ANI 0
CCI 0
CCI 0
“1”
“1.0”
“1.0”
DISPLAY
F-CIM 022
PROGRAM REFERENCED I/O
#
There is an F_CIM number associated with each function block. The blocks are
referenced using their F-CIM number. Certain blocks can be reused in the program.
These blocks are of type R. Examples of reusable blocks: Math, Logic, Read, Write etc.
Certain blocks can be used only once in the program. These blocks are of type N.
Examples of blocks that can be used only once: PID0, PID1, SP1 etc. Table 9-2 gives a
complete listing of the blocks, their inputs and type.