Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 45)

Training Manual
Front Face Configuration Lab Part 3 – Module Configuration
5 -5
• Press F3 to accept this value. The display is returned to the Analog Input
parameter list. The new SPAN value is displayed.
• Using the and pushbutons, move the pointer to the
ZERO parameter and press
F3. The default value of Zero is 0.
• Press F3 now to accept this default value. We have now configured the value of
Span and Zero for the analog input.
3. Change the control range for the single loop.
• Press the F1 button until the Configuration Main Menu is displayed. We will now
change Control Loop 0’s Instrument Range (IR) and Instrument Lower Range (ILR)
to 300.00 and Zero to 0.
• Using the setpoint increase arrow or the setpoint decrease arrow , place the
pointer beside the CONTROL menu item.
• Press F3 to accept the selection. The controller will display a list of the control
module ID numbers. If tag names for the control modules have been previously
assigned, the tag names will be displayed along side the module ID numbers.
Figure 5.5
Control Module
selection list
• Using the setpoint increase or decrease arrow, place the pointer beside the
0- menu item and press the F3 button.
• Control Module 0 parameters will be displayed on the screen as shown below: