Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 114)

Training Manual
Micro-Tools Lab
8 - 26
Figure 8.35.
Data Tables
• This will change the value of control loop 0’s setpoint. The value that is shown
near the address on this dialog box may not change instantly. To verify that you
have written the value for the setpoint, click on the Refresh button at the bottom
left. The current value of the setpoint should now be shown on the window. Refer
to the figure above.
• You can close the Database values dialog box by clicking on the Close button at
the bottom right.