Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 161)

Training Manual
F-TRAN Programming Lab
10- 15
Figure 10.24.
Data Tables
• Select the H VALUES tab. Since the analog output of our controller is looped
back to the input, our analog input value (H000) should now read a value of 50.0.
Our control program instruction was to assign the database value of H000 to
database location C100. We can see if the program worked by looking at the value
of C100 in the Data Tables. Both locations should be the same. If we change the
value at C000, we should see the same value at C100. See next figure:
Figure 10.25.
Data Tables