Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 143)

Training Manual
F-CIM Lab
9 - 29
Figure 9.28.
FCIM Block
Diagram
6. Connect the remaining lines:
1. ANI1 module output to RSP input of the SPG module
2. SPG Module SP output to SP input on the DEV module
3. DEV module DV output to the DV input on the PID module
4. PID module CO output to the CO input on the AMS module
5. AMS module OUT output to the ANO module input.
6. AMS module OUT output to the RF input on the PID module
7. AMS module AUT output to the CTC input on the PID module
At this point we have completed a simple strategy but there is a few more step to being
complete. When the drawing is complete, close the window.
7. Save the strategy: You will be prompted several times to save the new strategy.
Figure 9.29.
F-CIM Save
• Saving changes will overwrite any previous versions. You will next be asked if
you would like to view the step list. Answering Yes will give you the opportunity
to view the step list that you would have had to compile by hand before manual
entry.