Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 12)

Training Manual
Hardware Familiarization Lab
2 - 4
Figure 2 .3.
MC5000 –
Expansion board
4. Remove the Main board from the housing:
• Use the plastic front edge board ejector to remove the main printed circuit board
(PCB) from its rear terminal board socket and carefully slide the board forward.
See figure below: Use your finger to pull back on the top of the ejector. This will
leverage the board from its rear edge connector.
Figure 2 .4.
MC5000 –
Removing the main
board