Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 85)

Training Manual
Introduction to Micro-Tools
7 - 27
Figure 7.42.
SUPER32 Setup
Network Wizard
Network Attributes
6. Each serial communication port is required to have a name. This name is referred to as a
Network Name. Each Network Name should be unique. The names COM1, COM2, etc. are
reserved and should not be used.
7. The network position is selected from a list of available communication ports. The
MicroDCI communication services will compile the list from all the serial ports available
within the PC. A serial port which is currently in use by another application is not available
for use with MicroDCI communication Services and will not be listed.
8. When your selection and entries have been made, click Next to continue.
Figure 7.43.
SUPER32 Setup
Network Wizard
Network Mode