Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 150)

Training Manual
F-TRAN Programming Lab
10- 4
10.4 Instructions
10.4.1 Part 1 – A simple F-TRAN Program
We will program a simple Control F-TRAN program in this part of the lab. We will begin
by just moving data around. The process variable for Control Loop 0 is stored in database
location C100. The value for Analog Output 0 is stored at C000.
#
Your controller should have a loop back wire attached between analog output and
analog input. To do this connect terminal 2 to terminal 10 and terminals 5 to 12
The purpose of this is to use the analog output to drive the analog input. The analog
input will in turn be assigned to the process variable.
1. Create a new Control F-TRAN program:
• To create/edit a new control F-TRAN program, right mouse click Control within
the F-TRAN Programs folder in the project tree as shown in the next figure:
Figure 10 .1.
Project Explorer
• A sub menu will be displayed as shown in the figure above.
• Select New from this sub menu. The Open FTRAN File dialog box will be
displayed as shown in the next figure:
• Enter a name for the F-TRAN program. We will call it Ftran1. Type Ftran1 in the
file name field as shown in the next figure.