Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 156)

Training Manual
F-TRAN Programming Lab
10- 10
• Micro-Tools will build this file and an indicator as shown in the next figure will
appear showing the progress.
Figure 10.12.
F-TRAN Build
• After the file is built, a dialog box as shown in the next figure will be displayed.
This dialog box will show the amount of memory used by the program. Since our
program consisted of only 2 lines, it uses less than 1% of the memory and the
above dialog box will display 0%.
Figure 10.13.
F-TRAN Build
• Click on the YES button to view the results of the build. The Build status window
will be displayed next as shown in the figure below: This window will show the
results and the status of the build.
Figure 10.14.
F-TRAN Build
Status
• Click on the OK button if there are not indicated errors with the build.
8. Download the program into the controller:
#
The download procedure requires that a controller be present and communicating with
the MicroDCI Communication Services. It also requires that the controller name match
that of the controller folder. If either of these two conditions is missing, an error
message will be generated.
• With the controller still selected in the Project Manager, right mouse click on the
F-TRAN Image menu item on the right side of the project window as shown in the
next figure. Select Download from the pop up sub menu.