Micromod Micro-DCI: 53MC5000 Training Manual User Manual

Page 122

Training Manual

F-CIM Lab

9 - 8

So far it has been only paperwork. The next step is to enter the function block inputs and
parameters into the database of the controller.

Enter PROGRAM mode: Press the Dot button to enter the engineering mode. This may
require you to press the Dot button more than once. The engineering mode will display a
line of text at the bottom of the screen. The line of text will contain the word DISPLAY,
CONFIGURE or PROGRAM. Press the F2 button until PROGRAM is displayed at the
bottom as shown in the next figure:

Figure 9.2.

Program Mode

• Now press F3 to enter the program mode.
• 53MC5000 controllers can be configured for password protection. The controllers

you are using should not have any password requirements. When you are working
on controller in normal plant operations, passwords may be required. If you are
prompted for a password, the password must be entered before you may continue.

• The display will show either VIEW, BUILD, or ERASE at the bottom of the

screen as shown in the next screen.

You can perform three options in the F-CIM Program mode:

1. View – This mode is for viewing the step results of an F-CIM program

2. Erase – This mode is for erasing an existing F-CIM program

3. Build – This mode is for creating a new F-CIM program or modifying an existing

F-CIM program.