Micromod Micro-DCI: 53MC5000 Training Manual User Manual
Page 141
Training Manual
F-CIM Lab
9 - 27
module on the worksheet, left mouse click on the module. The module will be outlined
in red when selected. If you left mouse click on the module and hold the button down
you can drag the module to its new position.
3.
Configure the Analog Input 0:
• Double-click on the block to popup the module parameterization screen as shown
in the next figure. This will allow you to modify the parameters associated with the
module.
• Change the module to make sure that the configuration reference is the proper
module ID. To do this, click on the UP/DOWN arrows next to the Channel field
on the Analog Input Parameter Configuration menu and change the value to 0.
#
All modules selected from the function block list are always module zero.
Figure 9.26.
ANI Parameter
Configuration
• Click on the OK button to save the configuration of ANI0
4.
Add the other blocks: Let us continue by creating our single loop control strategy by
adding the remaining necessary modules to the editor. We will require the following
Control modules:
• Deviation Subroutine module (DEV)
• Setpoint Subroutine Module (SPG)
• PID Subroutine module (PID)
• Auto/Manual Switch Subroutine module.
• Analog output module
• Display module - The display module is used to control the pushbuttons for
screen manipulation
• Drag and drop each of these modules onto the worksheet. Your editor (work sheet)
will look like the next figure: The position of modules is not important.