Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 8)

Training Manual
Introduction
1 - 4
1.3 Communication Options
The 53MC5000 can be accessed using several different communication methods. There
are two standard communication ports provided; the Front Configuration Port and the
DataLink communications port. MicroLink, an optional third communication port, can
also be added.
Configuration Port: On the faceplate of the controller, an RS232 communication port is
provided. This is commonly used to make a point-to-point connection between a PC and
the controller.
DataLink Communication: On the rear of the controller, an RS485 multi-drop serial
communication port is also provided. This port is commonly used to connect a series of
controllers to a common PC. Operator Console or configuration software resident in the
PC can be used to access controller information for data acquisition/control or re-
configure/program the controller.
MicroLink Communication: An optional high-speed peer-to-peer communication
network can be provided in the controller. The peer-to-peer communication network
allows the controllers to pass information back and forth. This port is also commonly used
to connect a series of controllers to a common PC. Operator Console or configuration
software resident in the PC can be used to access controller information for data
acquisition/control or re-configure/program the controller.