Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 56)

Training Manual
Advanced Configuration Lab
6 - 6
• When all the changes have been entered, simply press the DOT button to exit
engineering mode.
Part C: Displaying the Modified Parameter Module:
1. Configuration of the Parameter Module Display:
• Press the F2 button until the MATH DEMO parameter module is displayed. It
should look like the figure below.
Figure 6.2.
MATH DEMO
Display
2. Testing the results
Remember we tied Input 0 and Input 1 of the controller as the inputs for the math
function. In this part of the lab, we will modify those inputs to verify the result. We
will do this in two steps
• Input 0 can be modified from the front panel of the display. The arrow to the left
of the INPUT 0 selection will allow us to modify the value in C090 (Input 0).
• Press the F3 button. At the bottom of the screen, the current value of INPUT 0 is
displayed. Using the / buttons to select the digit and then use the /
buttons, change the value in INPUT 0 to 100.0.