Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 22)

Training Manual
Front Face Configuration – Single Loop Lab
3 - 4
Figure 3 .3.
Loop display and
instrument in
CONFIGURE mode
• Press the ENTER (F3 – third key from the left) key to accept the selection. Now
we have selected the database location B0.
• After you pressed the F3 key, the bottom line of the display should look like:
B0
L
1 The value of B00 will be displayed in the lower right
corner of the display.
3. Change the value of B0 to 98.
• Press the setpoint-increase pushbutton. Continue pressing the pushbutton until
this character value is 9. The bottom of the display should look like: B0
L
9
• Now shift the character 9 to the left by one character position by pressing the
output decrease pushbutton once. A new character position is displayed. Press
the setpoint-increase pushbutton again to display 8 to the right of the digit 9.
The selection now should look like:
B0
L
98
• Press F3 to ENTER the selection. The value 98 will be written to the database
location B0. The MicroDCI logo will be displayed as shown in the next figure. The
bottom line of the display will look like:
POINT
L
B0