Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 25)

Training Manual
Front Face Configuration – Single Loop Lab
3 - 7
7. Exiting the Engineering mode:
• Do this by pressing the DOT pushbutton. The engineering mode line at the bottom
of the display will be removed and the screen information returned to normal. The
instrument will display the loop display as shown in the next figure:
Figure 3 .5.
Single loop display
8. Single Loop PID Display:
• The above single-loop controller display is for displaying PV, SP and OP in
numeric and bar formats. The PV is shown as a vertical bar graph on the left, the
setpoint is shown as an arrow along the PV bar graph and the output (OP) is shown
as a horizontal bar graph at the bottom.
#
The single loop strategy you configured also includes 4 other displays associated with
the control loop. These displays are added to the display list when CS1 was loaded from ROM.
Following is the list of pre-configured displays added to the display list for CS1.
• Single loop
• Single loop with PV trending
• Parameter
• Point status
• System Status