Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 123)

Training Manual
F-CIM Lab
9 - 9
The View Mode: The View command is used for displaying the contents of the
specified step. This includes the step number, the module function code assigned to this
step and the result or output of the step.
Figure 9 .3.
FCIM VIEW
To view the program code:
• Press the F3 button while VIEW is displayed at the bottom. This will take you to
the View mode and will display the step information as shown in the next figure.
The first numerical value represents the step number. The second value represents
the module function code and the third value represents the result of this step.
• Press the UP/DOWN buttons to scroll through the various steps.
• Press F1 once to exit the View mode – until you see VIEW at the bottom of the
screen and press the F3 key.
• When the data line appears, press the UP/DOWN pushbutton to change to the next
or previous step for viewing.
• When you are finished viewing, press the F1 key to exit back to the
VIEW/BUILD/ERASE menu selection.