Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 130)

Training Manual
F-CIM Lab
9 - 16
• Next we want to enter a value of H01 for the A Input of this F-CIM block. (Refer
to Table 9-3, Step 00). When the default entry for A is shown at the bottom
(*****), use the UP/DOWN/LEFT/RIGHT arrow keys to enter the value H01 at
the bottom and then press the F2 button to accept. Now H01 will be displayed
below A on the display and the pointer will jump to the B input as shown in the
next figure:
Figure 9.13.
FCIM BUILD
• The default value of B is shown at the bottom now. As per our work sheet (Table
9-3), we do not connect anything for the B and C inputs. Press F3 to save this step.
Now you will notice that REPLACE displayed at the bottom as shown in the next
figure. Programming of Step 00 is complete now. So we should now proceed to the
next step (Step 01).