Micromod Micro-DCI: 53MC5000 Training Manual - Manual (Page 49)

Training Manual
Front Face Configuration Lab Part 3 – Module Configuration
5 -9
• Press the F2 button and notice that the highlighted symbol changes as the cursor
position changes. When you reach the end of the tagname, the cursor wraps back to
the first position.
• Press the F2 button until the cursor is in the first character position. Using the /
buttons to select the character within a row of symbols and use the / to select the
row of characters. Since the character rows and columns wrap, it may be easier to
move backwards when trying to select a character. Place a
T in the first character
position.
Figure 5.10
Control Module Tag
name configuration
display
• Press the F2 will save the
T in the first character position and move the cursor to the
next character position. Use the / and / buttons to select the I character.
• Continue this procedure until the full tag name
TIC101 has been entered.
• When all the characters are correctly placed, pres F3 to write the tag name to the
database and return to the Control Module General parameter list.
5. Return to the main Configuration menu
• Pressing the F1 key will return the configuration screen to the previous configuration
level. Press the F1 key until you reach the main configuration window.
• You may exit the configuration mode at any time and any level of configuration. If
you mistakenly exit configuration by pressing the Engineering mode (DOT) button,