Xerox DocuPrint NC60 - Manual (Page 74)

Ethernet Menu
1-68 ❖ DocuPrint NC60 System Administrator Guide
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds (30*)
This item also causes an implicit job
end such as Control D in PostScript or
E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either Value Up or
Value Down is pressed. Holding
down Value Up or Value Down
causes continuous scrolling through
the values.
1. Press Menu Up or Menu
Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down
until you see:
Ethernet Menu
Port Timeout
3. Press Value Up or Value Down
until you see:
Port Timeout =
New Value
4. Press Enter. You will see: Ethernet Menu
Port Timeout
5. Press Online. You will see: Ready
Speed
Set the speed of the 10/100 Ethernet
interface card (appears only if the
option is installed).
The available values are:
Auto*
10/HALF
10/FULL
100/HALF
100/FULL
HALF = half duplex
FULL = full duplex
1. Press Menu Up or Menu
Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down
until you see:
Ethernet Menu
Speed
3. Press Value Up or Value Down
until you see:
Speed =
New Value
4. Press Enter. You will see: Ethernet Menu
Speed
5. Press Online. You will see: Ready
Table 1.15 Ethernet Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 1.15 Page 10 of 10