Xerox DocuPrint NC60 - Manual (Page 60)

Serial Menu
1-54 ❖ DocuPrint NC60 System Administrator Guide
Table 1.14 Serial Menu functions
Menu Item and Function Keystrokes Display
Port Enable
Enable or disable the serial port.
The available values are:
On*
Off
1. Press Menu Up or Menu
Down until you see:
Menus
Serial Menu
2. Press Item Up or Item Down
until you see:
Serial Menu
Port Enable
3. Press Value Up or Value Down
until you see:
Port Enable =
New Value
4. Press Enter. You will see: Serial Menu
Port Enable
5. Press Online. You will see: Ready
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds ( 30* )
This item also causes an implicit job
end such as Control D in PostScript or
E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either Value Up or
Value Down is pressed. Holding
down Value Up or Value Down
causes continuous scrolling through
the values.
1. Press Menu Up or Menu
Down until you see:
Menus
Serial Menu
2. Press Item Up or Item Down
until you see:
Serial Menu
Port Timeout
3. Press Value Up or Value Down
until you see:
Port Timeout =
New Value
4. Press Enter. You will see: Serial Menu
Port Timeout
5. Press Online. You will see: Ready
Table 1.14 Page 1 of 3