Xerox DocuPrint NC60 - Manual (Page 125)

Downloading Fonts and Macros
Chapter 3: Using the Hard Drive ❖ 3-3
Downloading Fonts and Macros
The Xerox DocuPrint NC60 PCL printer driver provides
you with the ability to download fonts and PCL macros to
the printer.
• To download fonts you must first install the
appropriate DocuPrint NC60 PCL Windows 3.1 or
Windows 95/98 driver. To download macros, you must
install the DocuPrint NC60 Windows PCL driver.
• “Temporary” fonts/macros downloaded to printer
memory on a job per job basis are cleared from the
printer's memory after each job.
• “Permanent” fonts downloaded to printer memory are
cleared from memory whenever the printer is powered
off. When the printer switches PDLs, its automatic
State Saving feature saves all fonts and macros.
In addition to downloading to memory through drivers,
the DocuPrint NC60 will support downloading of fonts
and macros to its hard disk by the use of the PJL
command FSDOWNLOAD. These files may be deleted
from the DocuPrint NC60 disk by the PJL command
FSDELETE.
• Fonts downloaded to the hard disk are stored in the
PCL Fonts and PS Fonts directories. Macros
downloaded to the hard drive are stored in the PCL
Macros directory. Fonts and macros stored in these
directories remain there until you delete them. They
are not cleared from the hard disk when the printer is
powered off. You can only delete a macro from the
hard disk if you know the name of the macro. Since
you cannot print a list of macros as you can for fonts,
it is important to keep a record of all downloaded
macros. Then, use the PJL FSDELETE command to
delete fonts and macros.