Xerox DocuPrint NC60 - Manual (Page 109)

Service Menu
Chapter 1: Configuring the Printer ❖ 1-103
OHP Mode
Set Overhead Projection mode to
allow discrete selection of settings for
fuser temperature and transfer bias
voltages to enhance the performance
for transparencies.
The available values are:
None
1,2,3,4
Default*
1. Press Menu Up or Menu
Down until you see:
Menus
Service Menu
2. Press Item Up or Item Down
until you see:
Service Menu
OHP Mode
3. Press Value Up or Value Down
until you see:
OHP Mode =
New Value
4. Press Enter. You will see: Service Menu
OHP Mode
5. Press Online. You will see: Ready
Select Tray
Select the source tray from which the
job is to be printed.
The available values are:
Tray 1*
Tray 2
Manual Feeder
Appears and is a choice only when the
optional Tray 2 is installed. The Tray
Sequence setting is ignored. Job to
media size or type mismatch will be
handled via the current Page Policy
settings.
1. Press Menu Up or Menu
Down until you see:
Menus
Service Menu
2. Press Item Up or Item Down
until you see:
Service Menu
Select Tray
3. Press Value Up or Value Down
until you see:
Select Tray =
New Value
4. Press Enter. You will see: Service Menu
Select Tray
5. Press Online. You will see: Ready
Table 1.20 Service Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 1.20 Page 3 of 8