Xerox DocuPrint NC60 - Manual (Page 61)

Serial Menu
Chapter 1: Configuring the Printer ❖ 1-55
Serial PDL
Set the default emulation for the serial
port.
The available values are:
Auto*
PCL
Postscript
1. Press Menu Up or Menu
Down until you see:
Menus
Serial Menu
2. Press Item Up or Item Down
until you see:
Serial Menu
Serial PDL
3. Press Value Up or Value Down
until you see:
Serial PDL =
New Value
4. Press Enter. You will see: Serial Menu
Serial PDL
5. Press Online. You will see: Ready
Flow Control
Set the handshaking parameters for
the serial port.
The available values are:
XON/XOFF
Robust XON/XOFF
Hardware*
1. Press Menu Up or Menu
Down until you see:
Menus
Serial Menu
2. Press Item Up or Item Down
until you see:
Serial Menu
Flow Control
3. Press Value Up or Value Down
until you see:
Flow Control =
New Value
4. Press Enter. You will see: Serial Menu
Flow Control
5. Press Online. You will see: Ready
Binary PS
Enable or disable the binary mode of
PostScript.
The available values are:
On
Off*
1. Press Menu Up or Menu
Down until you see:
Menus
Parallel Menu
2. Press Item Up or Item Down
until you see:
Parallel Menu
Binary PS
3. Press Value Up or Value Down
until you see:
Binary PS =
New Value
4. Press Enter. You will see: Parallel Menu
Binary PS
5. Press Online. You will see: Ready
Table 1.14 Serial Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 1.14 Page 2 of 3