Xerox DocuPrint NC60 - Manual (Page 140)

Cleaning the Printer
4-6 ❖ DocuPrint NC60 System Administrator Guide
Follow these steps to clean the rollers.
1 Raise the Front cover.
2 Locate the Print Drum.
When removing and inserting the Print Drum, do
not allow the green drum to touch any parts of the
printer. Contact may damage the delicate drum
degrading print quality.
3 Release the latches on both sides of the Print Drum.
4 Grasp the Print Drum by the handles and slide it up and
out of the printer, being careful to not allow the drum to
come into contact with the front cover of the printer.
The Print Drum is sensitive to prolonged exposure
to bright light. If the drum is exposed to excessive
light (the average fluorescent office lighting) for
more than 2 minutes, it may require up to 2 hours
of darkness to recover. Extended exposure will
cause permanent damage.
5 Set the Print Drum Module aside on several sheets of used
paper and cover the drum with several layers of paper to
avoid light contact.
6 Locate the paper sensor switch in the bottom of the
printer. See diagram above. Take care not to damage this
switch while cleaning.