Xerox DocuPrint NC60 - Manual (Page 47)

System Menu
Chapter 1: Configuring the Printer ❖ 1-41
Defaults
Sets default units. This is not changed
when a “Factory Default” is
performed.
The available values are:
Inches* (for 110V configuration)
Millimeters (for 220V configuration)
The following defaults are affected by
changing this setting:
• System Menu>Paper Size
• PCL Menu>FormLength.
1. Press Menu Up or Menu
Down until you see:
Menus
System Menu
2. Press Item Up or Item Down
until you see:
System Menu
Defaults
3. Press Value Up or Value Down
until you see:
Defaults =
New Value
4. Press Enter. You will see: System Menu
Defaults
5. Press Online. You will see: Ready
Power Saver
Set the time the printer will remain
idle before low power mode is
activated.
The available values, in minutes, are:
180
120
90
60
30*
15
Off (never enter Power Saver mode)
1. Press Menu Up or Menu
Down until you see:
Menus
System Menu
2. Press Item Up or Item Down
until you see:
System Menu
Power Saver
3. Press Value Up or Value Down
until you see:
Power Saver =
New Value
4. Press Enter. You will see: System Menu
Power Saver
5. Press Online. You will see: Ready
Table 1.10 System Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 1.10 Page 7 of 7