Savin 1045 - Manual (Page 99)

Printing Functions
85
5
Page Separation and Length
Reduction (Not Available in
Some Countries)
When the size of a received message
is longer than the paper loaded in the
machine, each page of the message
can be split and printed on several
sheets, or reduced and printed on a
single sheet. For example, this feature
splits the message if the length ex-
ceeds 0.79” or more, by reducing the
length within 0.79”. When a message
is split, the split mark (*) is inserted at
the split position and about 0.39” of
the split area is duplicated on the top
of the second sheet.
Note
❒ Your service representative can
customize this feature with the fol-
lowing settings. Bracketed values
are defaults.
• Reduction (on)
• Print split mark (on)
• Overprinting (on)
• Overprinting length (0.39”)
• Guideline for split (when mes-
sage is 0.79” longer than paper)
❒ You can adjust the overprinting
and reduction lengths within the
following ranges:
• Guideline for split: 0
∼6.1” (0.2”
steps)
• Overprinting length: 0.16”, 0.39”,
0.79”, 1.57”
Reverse Order Printing
Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this fea-
ture on, the machine will start print-
ing the message from the last page
received.
Note
❒ By default, this feature is turned
off. Switch it on with the Initial Set-
up RX.
⇒ P.126 “Reception Mode”
❒ When this feature is on, the first
page will be printed last.
❒ This feature uses Memory Recep-
tion.
ABC
(Document)
ND1X01E1
your machine
Print
ND1X01E2