Changing the user parameters – Savin 1045 User Manual
Page 150
Key Operator Setting
136
8
D
Select [ECM].
Note
❒ If "ECM" is not shown, press [U
U
U
U
Prev.]
or [
T
T
T
T Next].
E
Select [ON] or [OFF].
F
Press [OK].
Note
❒ To cancel this setting, press
[Cancel]
and the display will re-
turn to step
D.
G
Press the
{{{{User Tools/Counter}}}} key.
The initial display is shown.
Changing the User Parameters
The User Parameters allow you to customize various settings to match your
needs.
To change the function settings, set the user parameter switches.
Preparation
Access to some User Parameter Settings requires the installation of optional
equipment or that other settings be made beforehand.
-
-
-
-Switches and Bits
User Parameters are divided into Switches and each switch is divided into eight
bits. The right most bit is bit 0 and the left most is bit 7.
Switch 02 0
0
1
1
1
0
1
1
↓
↓
↓
↓
↓
↓
↓
↓
7
6
5
4
3
2
1
0