Savin 1045 - Manual (Page 179)

Changing Key Operator Settings
165
8
E
Enter a ID with number keys.
If you make a mistake, press the
{Clear/Stop} key or [Clear] and try
again.
F
Press [OK].
To cancel programing an ID, press
[Cancel]
and the display will return
to step
D.
G
Press the
{{{{User Tools/Counter}}}} key.
The initial display is shown.
Selecting Dial/Push Phone
Use this function to select a line type
when the machine is connected to a
G3 analog line.
A Dial or Push line is available for se-
lection. The factory default is set to
Push Phone.
Limitation
❒ If you are only connected to an
ISDN line, this function is not
available.
Note
❒ "G3-2" and "G3-3" is shown on the
display, depending on the number
of installed Extra G3 Interface
Units.
❒ Use the same procedure to pro-
gram and change this function.
A
Press the
{{{{User Tools/Counter}}}} key.
B
Press [Facsimile Features].
The Facsimile User Tools menu is
shown.
C
Select [Key Operator Tools].
D
Select [Select Dial/Push Phone].
Note
❒ If "Select Dial/Push Phone" is
not shown, press [
U U U U Prev.] or [T T T T
Next] .
E
Press [Push Button Phone] or [Dial
Phone (10PPS)]
to select line.