Savin 1045 - Manual (Page 96)

Reception Features
82
5
Reception Time
You can have the date and time print-
ed at the bottom of the message when
its received. This feature is turned off
by default—turn it on with the Initial
Setup Reception Mode settings.
⇒
P.126 “Reception Mode”
Limitation
❒ When a received message are
printed on two or more sheets, the
date and time is printed on the last
page.
Note
❒ The date and time when the mes-
sage was printed can also be re-
corded on the message. If you need
this feature, please contact your
service representative.
2-Sided Printing
You can have a received message
printed on both sides of the paper. By
default, this feature is turned off.
Switch it on with the Initial Setup Re-
ception Mode settings.
⇒ P.126 “Re-
ception Mode”
Limitation
❒ To use this function, all pages of
the received document must be of
the same size—inform the sending
party of this beforehand if neces-
sary. You must also have paper set
in your machine of the same size as
that sent by the sending party
(A4
→A4, B4→B4 are typical exam-
ples, whether A3 and B5 sizes are
correctly scan in will depend on
the fax machine). This machine
will correctly scan in landscape
A3, B4, A4, B5 and portrait A4, B5
and A5. The following table shows
the results that can be achieved
when sending and receiving using
this machine.
❒ This feature works only when all
pages are of the same width and
are received into memory.
❒ The machine will use Memory Re-
ception for 2-Sided Printing.
❒ This feature cannot be used with
Combine 2 originals.
❒ Printouts may vary depending on
how the sender set them.
1 2
2
1