Savin 1045 - Manual (Page 25)

Polling Transmission
11
1
C Press [Only Once] or [Save] to de-
lete or save the file after trans-
mission.
Note
❒ To delete the original imme-
diately after transmission, se-
lect [Only Once].
❒ To repeatedly send the origi-
nal, select [Save].
E
Press [OK].
The Transmission Mode menu is
shown. The [Polling TX] key is high-
lighted, and the specified mode is
shown above.
Note
❒ To cancel the Polling Transmis-
sion, press [Cancel]. The Trans-
mission Mode menu is shown.
F
Press [OK].
The initial display is shown.
G
Press the
{{{{Start}}}} key.
Polling Transmission Clear
Report
This report allows you to verify
whether Polling Transmission has
taken place.
Limitation
❒ This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save).
⇒ P.136 “Changing
the User Parameters”(Switch11,
Bit7)
Note
❒ This report is turned on by default.
You can turn it off if you wish.
⇒
P.136 “Changing the User Parame-
ters”(Switch03, Bit6)
❒ By default, a portion of the sent im-
age is printed on the report. You
can turn this off with the User Pa-
rameters.
⇒ P.136 “Changing the
User Parameters”(Switch04, Bit7)