Savin 1045 - Manual (Page 67)

Changing the Line Type
53
4
Changing the Line Type
The optional ISDN Unit or Extra G3 Interface Unit is required.
When the optional ISDN Unit and Ex-
tra G3 Interface Unit are installed,
you can connect to up to a maximum
of 3 lines.
Limitation
❒ When sending a fax, you can select
the line type if dialing with the
number keys or Chain Dial.
❒ Up to 2 Extra G3 Interface Units
can be installed on this machine.
However, if the machine installs a
ISDN Unit, only one Extra G3 In-
terface Unit is able to install.
Note
❒ When you install the optional
ISDN Unit or Extra G3 Interface
Unit, you can specify the line type
home position from "Gen. Set-
tings/Adjust". By default, the ma-
chine is set to "G3 Auto".
⇒ P.120
“General Setting/Adjustment”
❖ ❖ ❖ ❖ G3
G3 is selected after power up or
when the machine is reset. If you
install Extra G3 Interface Unit, you
can select "G3-1", "G3-2" or "G3-3"
depending on the number of the
installed unit.
❖ ❖ ❖ ❖ G4
ISDN line is selected.
Limitation
❒ If you select G4 mode, JBIG
compression is not available.
❖ ❖ ❖ ❖ Which line is used for G3 transmis-
sions?
ISDN lines can be used for G3 com-
munication as well as G4 commu-
n i c a t i o n s . I f t h e m a c h i n e
connected with an ISDN and ana-
log (PSTN) line, each line can be
available by selecting "G3 Auto".
Select "I-G3" when you use the
ISDN line for a G3 transmission.
Note
❒ If you wish to use an analog
(PSTN) line for G3 transmis-
sion, contact your service repre-
sentative.
❒ When you use G3 with ISDN,
you can set the sub-address.