Cable connections – ProSoft Technology MVI56-104S User Manual
Page 153

Reference MVI56-104S
♦ ControlLogix Platform
User Manual
IEC 60870-5-104 Server Communication Module
ProSoft Technology, Inc.
Page 153 of 188
November 18, 2009
Review the Configuring the MVI56-104S Module (page 23) chapter for a
complete list of the parameters that must be defined for a server. The IEC 60870-
5-104 Interoperability Document for the MVI56-104S Server Module contains a
listing of the protocol support supplied in the module.
5.5 Cable
Connections
The MVI56-104S module has the following functional communication
connections installed:
One Ethernet port (RJ45 connector)
One RS-232 Configuration/Debug port (RJ45 connector)
5.5.1 Ethernet
Connection
The MVI56-104S module has an RJ45 port located on the front of the module
labeled "Ethernet", for use with the TCP/IP network. The module is connected to
the Ethernet network using an Ethernet cable between the module’s Ethernet
port and an Ethernet switch or hub.
Note: Depending on hardware configuration, you may see more than one RJ45 port on the
module. The Ethernet port is labeled "Ethernet".
Warning: The MVI56-104S module is NOT compatible with Power Over Ethernet (IEEE802.3af /
IEEE802.3at) networks. Do NOT connect the module to Ethernet devices, hubs, switches or
networks that supply AC or DC power over the Ethernet cable. Failure to observe this precaution
may result in damage to hardware, or injury to personnel.
Important: The module requires a static (fixed) IP address that is not shared with any other device
on the Ethernet network. Obtain a list of suitable IP addresses from your network administrator
BEFORE configuring the Ethernet port on this module.