TA Triumph-Adler DCC 2520 - Manual (Page 35)

Copy Functions
1-19
Border Erase
Prevents the appearance of shadows from around the edges of originals.
Choose from the following Border Erase modes.
• Sheet Border Erase – Use this mode to erase black borders around the single sheet original.
• Book Border Erase – Use this mode to erase black borders around the edges and in the
middle of the original such as a thick books. You can specify the widths individually to erase the
borders around the edges and in the center of the book.
• Separate Border Erase – Use this mode to specify border widths individually on all sides to
erase.
The border widths that can be set for each mode are as follows.
NOTE: You can set the default width for erasing borders. For further details, refer to Erasing
Borders on page 7-10.
Sheet Border Erase
Follow the steps as below to erase the black borders from around the edges of the single sheet
original.
1 Place the original.
2 Press [Function].
3 Press [Border Erase] ([Erase Mode]).
Model Type Range
Inch models 0 - 2" (1/8" increments)
Metric models 0 - 50 mm (1 mm increments)
Original Copy
Original Copy
Original Copy